{"id":24467,"date":"2020-10-26T08:07:44","date_gmt":"2020-10-26T06:07:44","guid":{"rendered":"http:\/\/cornay.co.za\/wp\/?p=24467"},"modified":"2020-10-26T08:07:44","modified_gmt":"2020-10-26T06:07:44","slug":"a-unique-display-makes-an-unusual-clock","status":"publish","type":"post","link":"http:\/\/cornay.co.za\/wp\/2020\/10\/26\/a-unique-display-makes-an-unusual-clock\/","title":{"rendered":"A Unique Display Makes An Unusual Clock"},"content":{"rendered":"

Do you know the clock speed of the computer you’re reading this article on? Maybe Hackaday readers are more likely to reply “Yes!” to that question than the general public, but if there’s a takeaway it’s that for most computer users their clock speed is now an irrelevance. It’s quick enough for the job in hand and that’s all that matters. This was not always the case though, and a few decades ago the clock speed of a PC was its major selling point. Beige boxes would have seven-segment displays lit up with the figure, and it was an unusual example of one that [Ken Yap] used to produce a clock that he believes is one-of-a-kind<\/a>; unless by some slim chance somebody else has rescued the same part.<\/p>\n

The displays were hard wired without any signals from the processor, and what makes this one unusual is that as well as having a couple of digits in yellow it also sports a segmented “MHz” in red. This would have been quite a big deal on your 486 back in about 1994. To make a clock from this unpromising start required a little creative thinking, and he manages it by using the “M” and the “H” digits to represent minutes and hours, and displaying each figure in turn. The display is wired on a piece of protoboard with an STM8 dev board, and yes, as you can see in the very short video below the break, it does tell the time.<\/p>\n

Custom displays are more usually seen in the world of LCDs than LEDs, so this one remains a rarity on these pages. Happily there are projects out there in which people spin their own takes on the idea<\/a>.<\/p>\n

<\/span><\/p>\n